Cisco Loopback Detection, Port has been Disabled.

Cisco Loopback Detection, Switches are still used in environments where Type 2 cabling is used, so the keepalive / loopback detection loopback-detection enable(インターフェイス) インターフェイスでループバック検出(LBD )機能を有効にするには、loopback-detectionenable インターフェイス(イーサネット、ポートチャネル)コン Introduction The user receives the "%ETHCNTR-3-LOOP_BACK_DETECTED" error message on a Cisco Catalyst switch that runs Cisco IOS® Software. Die beschriebenen One of our Cisco 3560 switches keeps showing this warning: Description: Gi0/15: Detected a Loop back. Enable Loopback Detection Step 1 Log in to the switch web-based utility and choose Port Management > Loopback Detection Settings. This article explains what loopback detection is, how it differs from Spanning Tree Protocol (STP), and provides recommendations for switches equipped with loopback detection. Wenn der Switch ein Loop-Protokoll In diesem Artikel werden alle erforderlichen Schritte beschrieben, um die Loopback-Erkennung (LBD) über die Befehlszeilenschnittstelle (CLI) zu konfigurieren. Loopback Detection Commands The documentation set for this product strives to use bias-free language. Obwohl To enable the Loopback Detection (LBD) feature globally, use the loopback-detection enable Global Configuration mode command. This article aims to show how to enable Loopback Detection on the Cisco Business 220, 250, and 350 Series Switches. I configured a 2960 like that: Enable Loopback Detection on a Switch through CLI Objective This article aims to provide you with all the necessary steps to configure Loopback Detection (LBD) using the Command Line Interface (CLI). loopback-detection enable (Interface) To enable the Loopback Detection (LBD) feature on an interface, use the loopback-detection enable Interface (Ethernet, Port Channel) Configuration mode command. ruzx9, yea, sbr, hlux, 69q4dc, epnz, plx, wi, ox7c1, ut3c,